Hyundai Equus: Programming HomeLink®
Second generation VI (2009–2026) / Hyundai Equus 2009-2026 Owners Manual / Features of your vehicle / Mirrors / Programming HomeLink®
Second generation VI (2009–2026) / Hyundai Equus 2009-2026 Owners Manual / Features of your vehicle / Mirrors / Programming HomeLink®
✽ NOTICE
- When programming a garage door opener, it is advised to park the vehicle outside of the garage. • It is recommended that a new battery be placed in the hand-held transmitter of the device being programmed to HomeLink® for quicker training and accurate transmission of the radio-frequency signal.
- Some vehicles may require the ignition switch to be turned to the second (or "accessories") position for programming and/or operation of HomeLink. • In the event that there are still programming difficulties or questions after following the programming steps listed below, contact HomeLink® at: www.homelink.com or 1-800-355-3515.
Compass function
The Compass can be turned ON and OFF and will remember the last state when the
ignition is cycled. To turn the display feature ON/OFF:
1. Press and release the button
within 1 second to turn the ...
Programming
To train most devices, follow these instructions:
1. For first-time programming, press and hold the two outside buttons (
,
), HomeLink® Channel 1 and Channel 3, until the indicator light begin ...
See also:
Specifications
Tightening Torques
ItemN.mkgf.mlb-ftDriver airbag (DAB)7.8 ~ 10.80.8 ~ 1.15.8 ~ 8.0Passenger airbag (PAB)7.8 ~ 11.80.8 ~ 1.25.8 ~ 8.7Side airbag (SAB)6.9 ~ 8.80.7 ~ 0.95.1 ~ 6.5Curtain airbag (C ...
Rear Glass Defogger Relay Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear glass defogger relay (A) from the engine room relay box.
3.
There should be continuity between the No.87 and ...
Trunk Lid Latch Components and Components Location
Component Location
1. Trunk lid latch
...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com