Hyundai Equus: Line Pressure Control Solenoid Vale Specifications
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Line Pressure Control Solenoid Vale Specifications
| Specifications |
| Control Pressure kpa (kgf/cmx, psi) | 0~500.14 (0~5.1,0~72.54) |
| Current value(mA) | 0~850 |
| Internal resistance(x) | 4.8~5.4 |
Line Pressure Control Solenoid Vale Description and Operation
Description
Line presure control solenoid valve is attached to the valve
body. This variable force solenoid valve directly controls the hydraulic
pressure inside the line presure . ...
Line Pressure Control Solenoid Vale Schematic Diagrams
Circuit Diagram
...
See also:
35R Clutch Control Solenoid Valve(35R/C_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Instrument Cluster Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the cluster fascia panel after loosening the screws.
(Refer to Body - "Cluster Fascia Panel")
3.
Remove the cluster asse ...
Fuel Pump Motor Components and Components Location
Components
Pin NO.ItemDescription1Upper body3-phase coil power supply, fuel delivery, and sealing2Stator assemblyCreates an N pole and S pole flux to induce the rotor to turn.3rotor assemblyTorqu ...
Categories
Hyundai Equus Manuals
