Hyundai Equus: 4&OD Clutch Control Solenoid Valve Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / 4&OD Clutch Control Solenoid Valve Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / 4&OD Clutch Control Solenoid Valve Repair procedures
| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Disconnect the E Module connector. |
| 3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
| 4. |
Check that the resistance is within the specification. |
4&OD Clutch Control Solenoid Valve Schematic Diagrams
Circuit Diagram
...
35R Clutch Control Solenoid Valve(35R/C_VFS) Description and Operation
Description
35R Clutch control solenoid valve is attached to the valve
body. This variable force solenoid valve directly controls the hydraulic
pressure inside the 35R Clutch. ...
See also:
Repair procedures
Inspection
System Parameterization
Parameterization of the system has to be performed to find
the amount of pulses needed to open the trunk. Due to tolerances not
every car is equal. Therefore ...
Repair procedures
Removal
Front Blind Camera
1.
Remove the front bumper cover.
(Refer to Body - "Front Bumper")
2.
Remove the front blind camera (B) after removing the connector (A) and screws (4EA).
Back ...
Smart Key Receiver Repair procedures
Removal
1.
Disconnect the negatiev (-) battery terminal.
2.
Remove the glove box housing.
(Refer to Body - "Glove Box Housing")
3.
Remove the RF receiver (B) after disconnecting the conne ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com