Hyundai Equus: 4&OD Clutch Control Solenoid Valve Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / 4&OD Clutch Control Solenoid Valve Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / 4&OD Clutch Control Solenoid Valve Description and Operation
| Description |
4&OD Clutch control solenoid valve is attached to the
valve body. This variable force solenoid valve directly controls the
hydraulic pressure inside the 4&OD Clutch.
6 Speed Clutch Control Solenoid Valve Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
4&OD Clutch Control Solenoid Valve Specifications
Specifications
Direct control VFS[4&OD/C]
x Control type : Normal high type
Control Pressure kpa (kgf/cmx, psi)0~1569.06 (0~16,0~227.57)Current value(mA)0~1100 Internal resistanc ...
See also:
Power Trunk Module Drive Unit Components and Components Location
Component Location
1. Gear motor2. Drive bracket3. Push rod4. Gear5. Drive arm6. Power trunk module control unit7. Push rod pin
...
Hill-start assist control (HAC)
A vehicle has the tendency to roll back on a steep hill when the driver begins
to accelerate after a stop. The Hill-start Assist Control (HAC) prevents the vehicle
from rolling back by operating t ...
Fuel Pump Control Module (FPCM) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Check the output voltage of fuel pressure sensor (FPS).
Specification: Refer to “Specification”
...
Categories
Hyundai Equus Manuals
2011-2026 Copyright www.heqmanual.com