Hyundai Equus: Accelerator Pedal Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Fuel Delivery System / Accelerator Pedal Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Fuel Delivery System / Accelerator Pedal Repair procedures
| Removal |
| 1. |
Turn the ignition switch OFF and disconnect the negative (-) battery cable. |
| 2. |
Disconnect the accelerator position sensor connector (A). |
| 3. |
Disconnect the accelerator control connector (B). |
| 4. |
Remove the accelerator pedal in the direction of "Removal direction" in the figure after removing the installation bolt (B).
|
| Installation |
| 1. |
Install in the reverse order of removal.
|
Accelerator Pedal Description and Operation
Accelerator Pedal
Intelligent Accelerator Pedal (IAP) communicates with various modules by CAN communication.
IAP alarm the driver with foot power control and the vibration.Operation
...
Delivery Pipe Repair procedures
Removal
In case of removing the high pressure fuel pump, high
pressure fuel pipe, delivery pipe, and injector, there may be injury
caused by leakage of the high pressure f ...
See also:
AVN Antenna Repair procedures
Inspection
Glass Antenna Test
1.
Wrap aluminum foil (A) around the tip of the tester probe (B) as shown.
2.
Touch one tester probe to the glass antenna terminal (A) and
move the other teste ...
Fuel Pressure Sensor (FPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Check the output voltage of fuel pressure sensor (FPS).
Specification: Refer to “Specification”
Removal
1.
Tu ...
Sedan Rear Body
Rear body
Roof panel rear cornerSide outer panel rear cornerRear parkage tray panel tooling hole(O23)Side outer panel rear cornerTooling hole (14X10)Tooling hole (O10)
...
Categories
Hyundai Equus Manuals
2011-2026 Copyright www.heqmanual.com