>

Hyundai Equus: Fuel Pump Control Module (FPCM) Repair procedures - Fuel Delivery System - Engine Control/Fuel System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Fuel Pump Control Module (FPCM) Repair procedures

Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Check the output voltage of fuel pressure sensor (FPS).

Specification: Refer to “Specification�

    Fuel Pump Control Module (FPCM) Schematic Diagrams
    Circuit Diagram ...

    Fuel Pressure Sensor (FPS) Description and Operation
    Description The fuel pressure sensor (FPS) is installed on top of the low pressure fuel pump and measures the pressure of the low pressure fuel line. Based on the current fuel pressure and the ...

    See also:

    Blade inspection
    ✽ NOTICE Commercial hot waxes applied by automatic car washes have been known to make the windshield difficult to clean. Contamination of either the windshield or the wiper blades with ...

    Engine Control Module (ECM) Repair procedures
    Removal     When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the case of installing used ECM] 1) Perform "ECM Neutra ...

    Drive belts
    Inspect all drive belts for evidence of cuts, cracks, excessive wear or oil saturation and replace if necessary. ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com