>
Hyundai Equus: Fuel Pump Motor Repair procedures
| Removal |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
| 2. |
"Release the residual pressure in fuel line.
(Refer to Fuel Delivery System -""Release Residual Pressure in Fuel Line"")" |
| 3. |
Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump") |
| 4. |
Remove the sub fuel sender.
(Refer to Fuel Delivery System - "Sub Fuel Sender") |
| 5. |
Disconnect the suction hose (A). |
| 6. |
Remove the head assembly (C ) after removing the fixing hook (B).
|
| 7. |
Disconnect the dual hose (A).
|
| 8. |
Release the fixing hook, and then remove the free filter (A) and fuel pump motor (B).
|
| Installation |
| 1. |
Install in the reverse order of removal. |
Fuel Pump Motor Components and Components Location
Fuel Sender Assembly Repair proceduresCompressor Repair procedures
Removal
1.
If the compressor is marginally operable, run the engine at
idle speed, and let the air conditioning work for a few minutes, then
shut the engine off.
2.
Disconnect the negative ...
Ignition Coil Specifications
Specification
ItemSpecification Primary Coil Resistance (x)0.62 ± 10% [20°C (68°F)]Secondary Coil Resistance (kx)7.0 ± 15% [20°C (68°F)]
...
Blind spot detection system (BSD) (If equipped)
The BSD (Blind spot detection) system uses a radar sensor to alert the driver
while driving.
It senses the rear side territory of the vehicle and provides information to
the driver.
(1) BSD (B ...