>
If the Smart Key is not working properly, try replacing the battery with a new one.
Battery Replacement of Conventional Smart Key
Battery Type: CR2032 To Replace the Battery:
1. Pry open the rear cover of the Smart Key.
2. Remove the old battery and insert the new battery. Make sure the battery position
is correct.
3. Reinstall the rear cover of the Smart Key.
Battery Replacement of Card Type Smart Key
Battery Type: CR2412 To Replace the Battery:
1. Pull out the battery and battery cover.
2. Remove the old battery and insert the new battery. Make sure the battery position
is correct.
3. Reinstall the battery cover and battery.
✽ NOTICE
Rail Pressure Sensor (RPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine speed.
ConditionOutput Voltage (V)Idle Approx. 1.21, ...
Cleaning the lap/shoulder belt webbing
Clean the belt webbing with any mild soap solution recommended for cleaning upholstery
or carpet. Follow the instructions provided with the soap. Do not bleach or re-dye
the webbing because this m ...
TPMS Sensor Repair procedures
Removal
Tire Removal
1.
Deflate tire & remove balance weights.
•
The tire bead should be broken approx. 90° from the valve side of the wheel. The bead breaker should ...