Hyundai Equus: Starter Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Electrical System / Starting System / Starter Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Electrical System / Starting System / Starter Description and Operation
| Description |
The starting system includes the battery, starter, solenoid
switch, ignition switch, inhibitor switch (A/T), clutch pedal switch
(M/T), ignition lock switch, connection wires and the battery cable.
When the ignition key is turned to the start position, current flows and energizes the starter motor's solenoid coil.
The solenoid plunger and clutch shift lever are activated,
and the clutch pinion engages the ring gear.The contacts close and the
starter motor cranks.
In order to prevent damage caused by excessive rotation of
the starter armature when the engine starts, the clutch pinion gear
overruns.
In conjunction with the ISG function, the starter motor must
do a great deal more work. Therefore, the starter motor is configured
for a significantly higher number of start cycles. The components of the
starter motor have been adapted to the higher requirements.
| 1. Solenoid 2. Brush 3. Armature 4. Overrun clutch |
Troubleshooting
Troubleshooting
•
The battery must be in good condition and fully charged for this troubleshooting.
...
Starter Specifications
Specification
ItemSpecificationRated voltage12 V, 1.7 kWThe number of pinion teeth13Performance[No-load, 11.5 V]AmpereMax. 85 ASpeedMin. 2,550 rpm
...
See also:
Schematic Diagrams
ESP Circuit Diagram
ESP Connector Input/Output
[Standard]
[Premium]
Connector TerminalSpecificationPin NoDescriptionStandardPremium2931IGNITION1(+)High level of wake up voltage : 4.5V < ...
Room Lamp Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Detach the lamp lens and reflector (A) from the room lamp with a flat-tip screwdriver.
3.
Remove the room lamp (A) after removin ...
Accelerator Pedal Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the accelerator position sensor connector (A).
3.
Disconnect the accelerator control ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com