>
Removal |
1. |
Disconnect the rear oxygen sensor (HO2S) connector (A) on LH and RH side. |
2. |
Remove the front muffler (A) on LH and RH side.
|
3. |
Remove the center muffler (B) after removing the tunnel stay (A).
|
4. |
Remove the main muffler (A). |
5. |
Installation is reverse order of removal. |
Air Quality Sensor (AQS) Description and Operation
Desciption
The Air Quality Sensor (AQS) is located at the center support
in front of the engine radiator. It detects hazardous elements in
ambient air providing output signal to the control.
A ...
Injector Drive Box (IDB) Schematic Diagrams
Injector Drive Box (IDB)
IDB Connector
ECM Terminal Function
Connector [C200-IDB]
Pin No.DescriptionConnected to1ECM groundChassis ground2ECM groundChassis ground3Battery power (B+)Main rela ...
Power Seat Module(PSM) Description and Operation
Description
1.
Power Seat Module (PSM)
(1)
Main features
ItemDescriptionInstallation location Lower section of the driver side seatComponent configuration
1.
Embedded with CAN Communication ...