>
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach normal operating temperature.
3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil to return to the oil pan.
4. Pull the dipstick out, wipe it clean, and re-insert it fully.
WARNING - Radiator hose
Be very careful not to touch the radiator hose when checking or adding the engine oil as it may be hot enough to burn you.
5. Pull the dipstick out again and check the level. The level should be between F and L.
CAUTION
If it is near or at L, add enough oil to bring the level to F. Do not overfill.
Use a funnel to help prevent oil from being spilled on engine components.
Use only the specified engine oil. (Refer to “Recommended lubricants and capacities” in section 8.)
Repair procedures
Inspection
System Parameterization
Parameterization of the system has to be performed to find
the amount of pulses needed to open the trunk. Due to tolerances not
every car is equal. Therefore ...
Filter replacement
1. With the glove box open, remove the stoppers on both sides to allow the glove
box to hang freely on the hinges.
2. Remove the cylinder at the left of the glove box.
3. Remove the cl ...
Description and Operation
Function
B+ and Power Window Enable
ECU power ought to be supplied from B+ in order to secure the RAM and its memory.
ECU observes the level of power window enable to decide the
state (normal ...