Hyundai Equus: Controller

Intake Actuator Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 ...

Heater & A/C Control Unit Components and Components Location

Component Connector Pin Function Pin No.Connector A Function1Ground2Rheostat (Illumination -)3Rear Defog Switch4-5Detent Out (+)6HTD 7Illumination + (Tail)8-9Ground10-11Climate CAN High12 ...

See also:

Battery Repair procedures
Removal 1. Disconnect the battery sensor connector (A), battery nagative terminal (B) and positive terminal (C). 2. Disconnect the vent hose connector (A) from the battery air vent hole. 3. ...

Rear Center Seat Belt Retractor Repair procedures
Replacement     • When installing the belt, make sure not to damage the retractor. 1. Remove the rear package tray trim. (Refer to Interior Trim - "Rear Package Tray ...

Warning type
The system will activate when: 1.The system is on 2.Vehicle speed is above 9.3 mph (15 km/h) 3.Other vehicles are detected in the rear side If a vehicle is detected within the boundary of the ...