>
Hyundai Equus: Blower Motor Repair procedures
| Inspection |
| 1. |
Connect the battery voltage and check the blower motor rotation.
|
| 2. |
If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation. |
| 3. |
Replace the blower motor if it is proved that there is a problem with it.
|
| Replacement |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the cowl side trim.
(Refer to Body - "Cowl Side Trim") |
| 3. |
To remove the crash pad under cover [RH] (A), press both sides of the locking pin and then pull it down.
|
| 4. |
Disconnect the under lamp connector (A).
|
| 5. |
Disconnect the blower motor connector (A) and then remove the blower motor (B) after loosening the screws.
|
| 6. |
Install in the reverse order of removal. |
Blower Unit Repair procedures
Power Mosfet Repair proceduresCylinder Head Components and Components Location
Components
[RH]
1. Cylinder head cover2. Cylinder head cover oil seal3. Cylinder head cover gasket4. Exhaust CVVT assembly5. Exhaust camshaft, RH6. Intake CVVT assembly7. Intake camshaft, RH8. C ...
Height Sensor Repair procedures
Removal
Height Sensor
1.
Disconnect the negative (-) battery terminal.
2.
Remove the height sensor linkage (A) installed on the front axle and rear axle.
(Number of height sensor : Air suspe ...
Rear Seat Belt Retractor Components and Components Location
Component Location
1. Rear seat belt retractor
...