Hyundai Equus: Compressor oil Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / Compressor oil Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / Compressor oil Repair procedures
| Oil Specification |
| 1. |
The HFC-134a system requires synthetic (PAG) compressor oil
whereas the R-12 system requires mineral compressor oil. The two oils
must never be mixed. |
| 2. |
Compressor (PAG) oil varies according to compressor model. Be sure to use oil specified for the model of compressor.
|
Handling of Oil
| 1. |
The oil should be free from moisture, dust, metal powder, etc. |
| 2. |
Do not mix with other oil. |
| 3. |
The water content in the oil increases when exposed to air.
After use, seal oil from air immediately. (HFC-134a Compressor Oil
absorbs moisture very easily.) |
| 4. |
The compressor oil must be stored in steel containers, not in plastic containers.
|
Compressor Oil Check
The oil used to lubricate the compressor circulates with the refrigerant.
Whenever replacing any component of the system or a large
amount of gas leakage occurs, add oil to maintain the original amount of
oil.
Oil total volume in system
PAG OIL : 120 ± 10cc (4.1±0.3oz.) |
Oil Return Operation
There is close affinity between the oil and refrigerant.
During normal operation, part of the oil recirculates with
the refrigerant in the system. When checking the amount of oil in the
system, or replacing any component of the system, the compressor must
run in advance for oil return operation. The procedure is as follows:
| 1. |
Open all the doors and engine hood. |
| 2. |
Start the engine and air conditioning switch to "ON" and set the blower motor control knob at its highest position. |
| 3. |
Run the compressor for more than 20 minutes between 800 and 1,000 rpm in order to operate the system. |
| 4. |
Stop the engine. |
Components and Components Location
Component Location Index
Engine Room
1. Receiver-drier2. Condenser3. Ambient Temperature Sensor4. Compressor5. Discharge Hose6. Suction & Liquid Tube Assembly7. Service Port (Low Pressure)8. ...
Refrigerant Line Repair procedures
Replacement
1.
Discharge refrigerant from refrigeration system.
2.
Replace faulty tube or hose.
Cap the open fittings immediately to keep moisture or dirt out of the sys ...
See also:
Rear Package Tray Trim Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply pr ...
Multi-view Camera Switch Repair procedures
Removal
Floor Console Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the floor console upper cover.
(Refer to Body - "Floor Console Assembly")
3.
Disconnect the consol ...
Rear Door Window Glass Repair procedures
Replacement
1.
Pull down rear door window glass by pressing the power window glass switch.
2.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
3.
After loosening the mo ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com