>

Hyundai Equus: Troubleshooting - General Information - Heating, Ventilation and Air Conditioning - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Troubleshooting

Troubleshooting
Problem Symptoms Table
Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor.
Use the table below to help you find the cause of the problem. The numbers indicate the priority of the likely cause of the problem. Check each part in order. If necessary, replace these parts.
After correcting the malfunction, check the complete system to ensure that performance is satisfactory.
Standard:
Symptom
Suspected Area
No blower operation
1. Blower fuse
2. Blower relay
3. Blower motor
4. Power mosfet
5. Blower speed control switch
6. Wire harness
No air temperature control
1. Engine coolant capacity
2. Heater control assembly
No compressor operation
1. Refrigerant capacity
2. A/C fuse
3. Compressor
4. A/C pressure transducer
5. A/C switch
6. Evaporator temperature sensor
7. Wire harness
Vented air not cold
1. Refrigerant capacity
2. Refrigerant pressure
3. Drive belt
4. Compressor
5. A/C pressure transducer
6. Evaporator temperature sensor
7. A/C switch
8. Heater control assembly
9. Wire harness
Insufficient cooling
1. Refrigerant capacity
2. Drive belt
3. Compressor
4. Condenser
5. Expansion valve
6. Evaporator
7. Refrigerant lines
8. A/C pressure transducer
9. Heater control assembly
No engine idle-up when A/C switch ON
1. Engine ECM
2. Wire harness
No air inlet control
1. Heater control assembly
No mode control
1. Heater control assembly
2. Mode actuator
No cooling fan operation
1. Cooling fan fuse
2. Fan motor
3. Engine ECM
4. Wire harness

    Special Service Tools
    Special Service Tools Tool (Number and name)IllustrationUse09977-3R000Disc & hub assembly bolt removerRemoval and installation of disc & hub assembly bolt ...

    Air Conditioning System
    ...

    See also:

    Front Pillar Trim Components and Components Location
    Component Location 1. Front pillar trim ...

    Auto Defogging Sensor Repair procedures
    Inspection To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC guide. Replacement 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remov ...

    Checking the washer fluid level
    The reservoir is translucent so that you can check the level with a quick visual inspection. Check the fluid level in the washer fluid reservoir and add fluid if necessary. Plain water may be ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com