>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad center panel.
(Refer to Body - "Crash Pad Center Panel") |
3. |
Remove the start/stop button connector (A) from the crash pad center panel. |
4. |
Remove the start/stop button (B) after loosening the screws. |
Installation |
1. |
Install the start/stop button after connecting the connector. |
2. |
Install the crash pad center panel. |
3. |
Connect the negative (-) battery terminal. |
35R Clutch Control Solenoid Valve(35R/C_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Tire maintenance
In addition to proper inflation, correct wheel alignment helps to decrease tire
wear. If you find a tire is worn unevenly, have your dealer check the wheel alignment.
When you have new tires instal ...
Front Washer Motor Repair procedures
Removal
1)
When servicing the washer pump, be careful not to damage the washer pump seal.
2)
Do not operate the washer pump before filling the washer reservoir.
Failure ...