>

Hyundai Equus: Power Mirror Switch Repair procedures - Power Mirrors - Body Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Power Mirror Switch Repair procedures

Inspection
1.
The DDM inputs can be checked using the GDS.
2.
To check the input value of door lock switch, select option "IPM".
3.
Select option "DDM (Driver Door Module)".
4.
Select option "Input/Output monitoring".

5.
To check the input value of door lock switch in force mode, select option "ACTUATION TEST".

Removal
Driver Power Mirror Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim. (Refer to the Body group - "Front Door")
3.
Disconnect the DDM module connector (A).

4.
Remove the DDM module with power mirror switch after loosening the mounting screws.

Installation
1.
Install the DDM module.
2.
Install the front door trim.
    Power Mirror Switch Components and Components Location
    Components ...

    Power Door Mirror Actuator Repair procedures
    Inspection 1. Remove the front door quadrant inner cover. Take care not to damage fixing clips. (Refer to Body - "Front Door") 2. Disconnect the power door mirror connector from the harness. ...

    See also:

    Components and Components Location
    Components 1. ESP control module (HECU)2. Steering angle sensor3. Rear wheel speed sensor4. Sensor cluster (Yaw rate & Lateral)5. Front wheel speed sensor ...

    Side Impact Sensor (SIS) Repair procedures
    Removal     • Removal of the airbag must be performed according to the precautions/procedures described previously. • Before disconnecting the side impact sensor conn ...

    Troubleshooting
    Troubleshooting Trouble symptomProbable causeRemedyHard steeringImproper front wheel alignmentRepairExcessive turning resistance of lower arm ball jointReplaceFlat tireAdjustNo power assistRepair ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com