Hyundai Equus: Front LCD monitor Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Premium AVN System / Front LCD monitor Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Premium AVN System / Front LCD monitor Repair procedures
| Removal |
Take care not to scratch the crash pad and related parts. |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the center fascia upper panel.
(Refer to Body - "Center Fascia Panel") |
| 3. |
Remove the front LCD monitor after loosening the mounting screws.
|
| Installation |
| 1. |
Install the front LCD monitor after connecting the connector. |
| 2. |
Install the center fascia panel.
|
Front LCD monitor Components and Components Location
Components
...
Rear LCD monitor Components and Components Location
Components
...
See also:
Troubleshooting
Troubleshooting
SymptomProbable causeRemedyExcessive play in steeringLoose yoke plugRetightenLoose steering gear mounting boltsRetightenLoose or worn tie rod endRetighten or replace as necessaryS ...
Intake Air Temperature Sensor (IATS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
Specification: Refer to "Specification"
...
Battery recharging by vehicle
After a jump start from a good battery, run the engine for 20-30 minutes at idle
or driving the vehicle before it is shutoff. Vehicle may not restart if you shut
it off before the battery had chan ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com