>

Hyundai Equus: Front Seat Shield Inner Cover Repair procedures - Front Seat - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Front Seat Shield Inner Cover Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly")
2.
Remove the front seat lower protector (A).

3.
After loosening the mounting bolt, then remove the front seat belt buckle (A).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.
Remove the cap (A) and then loosen the mounting screws.
5.
Using a screwdriver or remover, remove the front seat shield inner cover (B).

6.
Install in the reverse order of removal.
   
•
Replace any damage clips.
    Front Seat Shield Inner Cover Components and Components Location
    Component Location 1. Front seat shield inner cover ...

    Front Seat Back Cover Components and Components Location
    Component Location 1. Front seat back cover ...

    See also:

    Memory Power Seat Switch Schematic Diagrams
    Circuit Diagram (Power Seat Control Switch) ...

    To keep locks from freezing
    To keep the locks from freezing, squirt an approved de-icer fluid or glycerine into the key opening. If a lock is covered with ice, squirt it with an approved de-icing fluid to remove the ice. If ...

    Transmission Control Module (TCM) Repair procedures
    Inspection TCM Problem Inspection Procedure 1. TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis ground using the backside of TCM harness connector as TCM side check poin ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com