>
Hyundai Equus Manuals

Hyundai Equus: Front Seat Assembly Repair procedures - Front Seat - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Front Seat Assembly Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Assembly Repair procedures

Replacement
1.
Remove the safety belt (A) by turning it in the direction of arrow using a flat-head screwdriver.

2.
Remove the front seat track mounting cover.
3.
After loosening the mounting bolts and nuts, remove the front seat assembly (A).
Tightening torque :
Bolts : 34.3 ~ 53.9 N.m (3.5 ~ 5.5 kgf.m, 25.3 ~ 39.8 lb-ft)
Nuts : 23.5 ~ 35.3 N.m (2.4 ~ 3.6 kgf.m, 17.4 ~ 26.0 lb-ft)

4.
Disconnect the front seat integration connector (A).
[Driver's]

[Passenger's]

5.
Disconnect the rear monitor image cable connector (A).

6.
Install in the reverse order of removal.
   
SEAT MOUNTING BOLT INSTALLATION PROCEDURE
•
Set the seat into the most rearward position. Check that each slide is locked, and then tighten the front mounting bolt temporarily.
•
Set the seat into most forward position. Check that each slide is locked, and then Tighten the rear mounting bolt completely.
•
Set the seat into the most rearward position. Check the front mounting bolt completely.
•
Check that the seat operates to and fro smoothy and the locking portion locks properly.
    Front Seat Assembly Components and Components Location
    Component Location 1. Front seat assembly ...

    Front Seat Shield Outer Cover Components and Components Location
    Component Location 1. Front seat front shield outer cover2. Front seat rear shield outer cover ...

    See also:

    Exterior care
    Exterior general caution It is very important to follow the label directions when using any chemical cleaner or polish. Read all warning and caution statements that appear on the label. Finish mai ...

    Evaporator Core Repair procedures
    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater -"Heater Unit") 3. Remove the heater unit lower case (A) after loos ...

    Alternator Description and Operation
    Description The Alternator has eight built-in diodes, each rectifying AC current to DC current. Therefore, DC current appears at alternator "B" terminal. In addition, the charging voltage of this ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com