>
Hyundai Equus Manuals

Hyundai Equus: Repair procedures - Sunroof - Body (Interior and Exterior) - Hyundai Equus VI 2009-2025 Service ManualHyundai Equus: Repair procedures

Second generation VI (2009–2025) / Hyundai Equus VI 2009-2025 Service Manual / Body (Interior and Exterior) / Sunroof / Repair procedures

Adjustment
Inspect Sunroof Alignment
1.
Adjust the difference between the height of the glass roof panel (A) and glass weatherstrip (B).
Standard value [mm(in.)] :
Front edge : - 0.2 (- 0.0079)
Rear edge : ±0.2 (±0.0079)
Side edge : ±0.4 (±0.0157)

2.
Loosen the front screw and rear screw (A), adjust the height between the glass panel and roof panel.
Tightening torque :
2.0 ~ 3.9 N.m (0.2 ~ 0.4 kgf.m, 1.4 ~ 2.9 lb-ft)

Operating The Sunroof Emergency Handle
1.
Use the sunroof emergency handle to close or open the sunroof manually if the sunroof cannot be closed electronically due to motor or controller electrical malfunction.
2.
Operating method.
A.
Remove the roof trim.
B.
Push the emergency handle up into the hexagonal drive (A) of the sunroof motor. You must push hard enough to disengage the motor clutch; otherwise the emergency handle will slip due to incomplete fit in the motor.
C.
Carefully turn the emergency handle clockwise to close the sunroof.
D.
After closing the sunroof, wiggle the handle back and forth as you remove the tool from the motor, to ensure the motor clutch reengages.
E.
A 5mm hex socket may be used in place of the emergency handle, with a” Speeder” type handle.
   
•
Do not use power tools to operate the sunroof.
•
Damage to the components may occur.

    Components and Components Location
    Components 1. Glass panel2. Decoration cover3. Drip link4. Guide assembly5. Drip rail6. Sunshade7. Defector8. Defector link 9. Seal tape10. Motor11. Frame12. Set plate ...

    Sunroof Glass Components and Components Location
    Component Location 1. Sunroof glass ...

    See also:

    Rear Seat Assembly Repair procedures
    Replacement [Rear Seat Cushion Assembly] 1. Pull it up and remove the rear seat cushion assembly (A). 2. Install in the reverse order of removal.     • Make sure the ...

    Cylinder Block Repair procedures
    Disassembly Engine removal is required for this procedure.     • Use fender covers to avoid damaging painted surfaces. • To avoid damage, unplug the wiring connector ...

    Components and Components Location
    Component Location Index Engine Room 1. Receiver-drier2. Condenser3. Ambient Temperature Sensor4. Compressor5. Discharge Hose6. Suction & Liquid Tube Assembly7. Service Port (Low Pressure)8. ...

    Categories

    Hyundai Equus Manuals

    2011-2025 Copyright www.heqmanual.com