>
Hyundai Equus Manuals

Hyundai Equus: B Pillar Garnish Repair procedures - Body Side Molding - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: B Pillar Garnish Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Body Side Molding / B Pillar Garnish Repair procedures

Replacement
[B Pillar upper garnish]
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Take care not to scratch the body surface.
1.
Using a screwdriver or remover, remove the B pillar upper garnish (A).

2.
Disconnect the rubber (A) screw loose.

3.
Install in the reverse order of removal.
   
•
Replace any damaged clips.
•
Integrated silicon coating on the surface of the tube. (MS261-13)
[B Pillar lower garnish]
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Take care not to scratch the body surface.
1.
Remove the canter pillar lower trim.
(Refer to Interior Trim - "Center Pillar Trim")
2.
Using a screwdriver or remover, remove the B pillar upper garnish (A).

3.
Disconnect the rubber (A) screw loose.

4.
Loosen the mounting nuts, remove the B pillar lower garnish (A).

5.
Install in the reverse order of removal.
   
•
Replace any damaged clips.
•
Integrated silicon coating on the surface of the tube. (MS261-13)
    Side Sill Molding Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply p ...

    Sunroof
    ...

    See also:

    Rheostat Repair procedures
    Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the lower crash panel and then disconnect the rheostat connector. 3. Check for intensity of new rheostat switch. If th ...

    Smart Key Antenna Repair procedures
    Removal Interior 1 Antenna 1. Disconnect the negative (-) battery terminal. 2. Remove the AVN head unit. (Refer to Premium AVN System - "AVN Head Unit") 3. Remove the interior 1 antenna ...

    Exhaust Manifold Repair procedures
    Removal and Installation 1. Disconnect the negative terminal (A) from the battery. Tightening torque : 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft) 2. Remove the engine room cover (A ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com