>
Hyundai Equus Manuals

Hyundai Equus: Emergency Fastening Device (EFD) Repair procedures - Seat Belt Pretensioner - Restraint - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Emergency Fastening Device (EFD) Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Restraint / Seat Belt Pretensioner / Emergency Fastening Device (EFD) Repair procedures

Removal
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front seat assembly.
(Refer to Body - "Front Seat Assembly")
3.
Remove the front seat outer shield cover.
(Refer to Body - "Front Seat Outer Shield Cover")
4.
Disconnect the EFD system connector.
5.
Unscrew the mounting bolt from the front seat assembly, and then remove the EFD system (A).

Installation
1.
Disconnect the negative (-) cable from battery and wait for at least three minutes.
2.
Install the EFD system with the mounting bolt.
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
3.
Connect the EFD system connector.
4.
Install the front seat shield outer cover.
(Refer to Body - "Front Seat Outer Shield Cover")
5.
Install the front seat assembly.
(Refer to Body - "Front seat assembly")
   
Make sure the lock pin is connected in properly.
6.
Reconnect the battery negative cable.
7.
After installing the EFD system, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off.
    Emergency Fastening Device (EFD) Components and Components Location
    Components ...

    Pre-active Seat Belt (PSB) Description and Operation
    Description Pre-active Seat Belt (PSB) guarantees initial restraint performance by winding the seat belt right before a crash or dangerous condition and enhances the effects of the seat belt pr ...

    See also:

    Height Sensor Description and Operation
    Description The ground clearance sensor is one component of the ECS system. This sensor is installed between the vehicle body and lower suspension arm. It measures the ground clearance and sen ...

    Heater Core Repair procedures
    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater -"Heater Unit") 3. Remove the heater core cover (A) after loosening ...

    Front Pillar Trim Components and Components Location
    Component Location 1. Front pillar trim ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com