Hyundai Equus: 8LR Brake Control Solenoid Valve Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / 8LR Brake Control Solenoid Valve Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / 8LR Brake Control Solenoid Valve Repair procedures
| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Disconnect the E Module connector. |
| 3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
| 4. |
Check that the resistance is within the specification. |
8LR Brake Control Solenoid Valve Schematic Diagrams
Circuit Diagram
...
Line Pressure Control Solenoid Vale Description and Operation
Description
Line presure control solenoid valve is attached to the valve
body. This variable force solenoid valve directly controls the hydraulic
pressure inside the line presure . ...
See also:
Turn By Turn (TBT) Mode (if equipped)
This mode displays the state of the navigation. ...
Steering Wheel Remote Controller (SWRC) Repair procedures
Inspection
1.
Check for resistance between terminals in each switch position.
[LH Top (Audio)]
SwitchConnectorterminalResistance(±5%)Volume Down6-7240 xSeek Down510 xMode940 xVolume Up1.69 kxSe ...
Drive belts
Inspect all drive belts for evidence of cuts, cracks, excessive wear or oil saturation
and replace if necessary. ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com