>
Hyundai Equus Manuals

Hyundai Equus: Cluster Fascia Panel Repair procedures - Crash Pad - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Cluster Fascia Panel Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Crash Pad / Cluster Fascia Panel Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Using a screwdriver or remover, remove the center fascia upper panel (A).

2.
Install in the reverse order of removal.
   
•
Replace any damage clips.
    Cluster Fascia Panel Components and Components Location
    Component Location 1. Cluster fascia panel ...

    Center Fascia Panel Components and Components Location
    Component Location 1. Center fascia upper panel2. Center fascia lower panel ...

    See also:

    SRS Care
    The SRS is virtually maintenancefree and there are no parts you can safely service by yourself. If the SRS air bag warning light " " does not illuminate, when the Engine Start/Stop Butt ...

    ETC (Electronic Throttle Control) System Repair procedures
    Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Throttle ...

    Specifications
    Specifications ItemsSpecificationsRated voltageDC 12VOperating temperature range-22 ~ +176°F (-30°C ~ +80°C)Rated loadWasher switch0.2A (Relay load) ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com