>
Hyundai Equus: Brake Switch Repair procedures
| Removal |
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
| 2. |
Remove the lower crash pad.
(Refer to the Body - "Crash Pad") |
| 3. |
Disconnect the stop lamp switch connector (A).
|
| 4. |
Pull the locking plate (A) as indicated by the arrow.
|
| 5. |
Turn stop lamp switch 45° counterclockwise and remove it.
|
| 6. |
Remove the stop lamp switch. |
| Installation |
| 1. |
Fix the brake pedal arm and insert fully the stop lamp switch as hiding contact part.
|
| 2. |
After inserting, turn the stop switch (A) 45° clockwise, and then assemble locking plate (B) by pushing.
|
| 3. |
Confirm the gap between stop lamp switch and bracket.
|
| 4. |
Connect the stop lamp switch connector.
|
| 5. |
Install the lower crash pad.
(Refer to the Body - "Crash Pad") |
Rear Disc Brake Repair proceduresFront Wiper Motor Repair procedures
Removal
1.
Remove the windshield wiper arm (A) and blade after removing a nut.
Tightening torque :
27 ~ 31 N.m (2.8 ~ 3.2 kgf.m, 20 ~ 23 lb-ft)
2.
If necessary of removing the wiper blad ...
Troubleshooting
Troubleshooting
SymptomSuspect AreaRemedy (Refer to page)Water leaks from sunroofDirt accumulated in drain tubeClear dirt inside of drainClogged drain tubeBlow air into drain to remove dirtBroken ...
Filter replacement
It must be replaced when necessary, and should not be washed.
You can clean the filter when inspecting the air cleaner element. Clean the filter
by using compressed air.
Main air cleaner
1. ...