Hyundai Equus: Auto Defogging Actuator Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Heating, Ventilation and Air Conditioning / Heater / Auto Defogging Actuator Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Heating, Ventilation and Air Conditioning / Heater / Auto Defogging Actuator Description and Operation
| Description |
The auto defogging sensor is installed on front window glass.
The sensor judges and sends signal if moisture occurs to blow out wind
for defogging. The air conditioner control module receives a signal from
the sensor and restrains moisture and eliminates defog by the intake
actuator, A/C, auto defogging actuator, blower motor rpm and mode
actuator.
Console Temperature Control Actuator Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the console temperature control actuator connector.
3.
Verify that the console temperature control actuator operates
to the defr ...
Auto Defogging Actuator Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the auto defogging connector.
3.
Verify that the auto defogging actuator operates to the open
position when connecting 12V to ...
See also:
Record your key number
The key code number is stamped on the key code tag attached to the key set. Should
you lose your keys, this number will enable an authorized EQUUS dealer to duplicate
the keys easily. Remove the ...
ETC (Electronic Throttle Control) System Schematic Diagrams
Circuit Diagram
...
Blind spot detection system (BSD) (If equipped)
The BSD (Blind spot detection) system uses a radar sensor to alert the driver
while driving.
It senses the rear side territory of the vehicle and provides information to
the driver.
(1) BSD (B ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com