>
Hyundai Equus Manuals

Hyundai Equus: Trunk Lid Back Panel Repair procedures - Trunk Lid - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Trunk Lid Back Panel Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Trunk Lid / Trunk Lid Back Panel Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Take care not to scratch the body surface.
1.
Remove the trunk lid trim.
(Refer to Trunk Lid - "Trunk Lid Trim")
2.
Loosen the mounting nut, remove the trunk lid panel (A).

3.
Install in the reverse order of removal.
   
•
Make sure the connector are connected in properly.
•
Replace any damaged clips.
    Trunk Lid Back Panel Components and Components Location
    Component Location 1. Trunk lid back panel ...

    Trunk Lid Weatherstrip Repair procedures
    Replacement 1. Remove the trunk lid weatherstrip (A).     • Do not apply sealant to the body. 2. Install in the reverse order of removal.     â ...

    See also:

    Power Seat Motor Repair procedures
    Inspection Slide Motor Limit Switch 1. Disconnect the limit switch (A) and operate the limit switch. 2. Check for continuity between the terminals. 3. Make sure that the seat operation is ...

    Repair procedures
    Inspection Initialization and diagnosis sequence by using diagnostic equipment Below content summarize the procedure for A/S using Diagnostic equipment Download Parameter 1. Select "AFLS" menu ...

    Limousine Side Body
    Side body A Front side member tooling hole (O8)Fender apron panel tooling hole (O7)Front door hinge upper mounting hole (O13)Front door hinge lower mounting hole (O13) Fender mounting hole (O6.6 ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com