>
Removal |
1. |
Remove the rear wheel & tire.
|
2. |
Disconnect the trailing arm (A) from the rear axle by loosening the bolt & nut.
|
3. |
Disconnect the trailing arm (A) from the rear axle by loosening the bolt & nut.
|
4. |
Installation is the reverse of removal. |
Blower Motor Repair procedures
Inspection
1.
Connect the battery voltage and check the blower motor rotation.
2.
If the blower motor does not operate well, substitute with a known-good blower motor and check for proper oper ...
Interior care
Interior general precautions
Prevent chemicals such as perfume, cosmetic oil, sun cream, hand cleaner, and
air freshener from contacting the interior parts because they may cause damage or
discol ...
ON/OFF Solenoid Valve Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...