>
Hyundai Equus Manuals

Hyundai Equus: Repair procedures - Fuel Filler Door - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Fuel Filler Door / Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Take care not to scratch the body surface.
1.
Open the fuel filler door cap (A).

2.
Remove the fuel filler door mounting pin (A) by turning it counter clock-wise.

3.
After loosening the mounting clips, then remove the fuel filler door housing (A).
   
•
Pull out from inside of the packing part (B) When removing the fuel filler door housing.

4.
Using a clip remove or remover, remove the fuel fill door (A).

5.
Install in the reverse order of removal.
   
•
Make sure the fuel filler door locks/unlocks and opens/closes properly.
•
Replace any damaged clips.
    Components and Components Location
    Component Location 1. Fuel filler door ...

    Front Door
    ...

    See also:

    Rear Differential Carrier Components and Components Location
    Component 1. Rear differential carrier assembly Component 1. Pinion lock nut2. Companion flange3. Pinion oil seal4. Pinion front bearing5. Differential case6. Side oil seal7. Drain plug8. ...

    Fuel Pressure Control Valve Repair procedures
    Inspection 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the fuel pressure regulator valve connector. 3. Measure resistance between the fuel ...

    Rear Wheel Guard Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply p ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com