>
Hyundai Equus Manuals

Hyundai Equus: Rear Door Module Repair procedures - Rear Door - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Rear Door Module Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Module Repair procedures

Replacement
1.
Remove the rear door window glass.
(Refer to Rear Door - "Rear Door Window Glass")
2.
Remove the rear door outside handle.
(Refer to Rear Door - "Rear Door Outside Handle")
3.
Loosen the rear door outside handle base mounting screw (A).

4.
Disconnect the rear door curtains motor connector (A).

5.
Using a screwdriver or remover, remove the extension cover (A).
6.
Loosen the mounting bolts, remove the rear door curtains (B).
Tightening torque :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

7.
Loosen the mounting bolts and nuts, remove the rear channel (A).
8.
Loosen the door latch (C) screws, remove the module assembly (B).
Tightening torque :
(B) 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
(C) 6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

9.
Disconnect the connectors (A) and rear door module wiring harness (B).

10.
Install in the reverse order of removal.
   
•
The area of whole parts should be applied with sufficient grease.
•
Make sure connectors are connected properly and each rod is connected securely.
•
Make sure the door locks/unlocks and opens/closes properly
    Rear Door Module Components and Components Location
    Component Location 1. Rear door module ...

    Rear Door Outside Handle Components and Components Location
    Component Location 1. Rear door outside handle ...

    See also:

    Wipers & Washers
    A : Wiper speed control -MIST – Single wipe -OFF – Off -AUTO – AUTO control wipe -LO – Low wiper speed -HI – High wiper speed B : Auto control wipe time adjustment C :Wash with br ...

    Receiver-Drier Repair procedures
    Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with a L wrench (A). Tightening torque : 2.7 ~ 3.1 N.m (0.28 ~ 0.32 kgf.m, 2.0 ~ 2.3 lb-ft) ...

    Canister Close Valve (CCV) Description and Operation
    Description Canister Close Valve (CCV) is normally open and is installed on the canister ventilation line. It seals evaporative emission control system by shutting the canister from the atmosph ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com