Hyundai Equus: Lane Departure Warning System (LDWS) Unit Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Lane Departure Warning System (LDWS) / Lane Departure Warning System (LDWS) Unit Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Lane Departure Warning System (LDWS) / Lane Departure Warning System (LDWS) Unit Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the LDWS unit cover (A).
|
| 3. |
Remove the LDWS unit connector (A).
|
| 4. |
Remove the front side of roof trim to remove the LDWS unit mounting bolts.
(Refer to Body group - "Roof Trim") |
| 5. |
Remove the LDWS unit after loosening the mounting bolts.
|
| Installation |
| 1. |
Install the LDWS unit. |
| 2. |
Install the roof trim. |
| 3. |
Install the LDWS unit cover. |
| 4. |
Check LDWS system operation. |
See also:
Smart cruise control speed
To set cruise control speed:
1. Push the CRUISE (ON·OFF) button on the steering wheel to turn the system on.
The CRUISE indicator light in the instrument cluster will illuminate.
2. Accelerat ...
If engine turns over normally but does not start
1. Check fuel level.
2. With the Engine Start/Stop Button in the OFF position, check all connectors at
ignition coils and spark plugs. Reconnect any that may be disconnected or loose.
3. If the en ...
Fuel Pump Control Module (FPCM) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Check the output voltage of fuel pressure sensor (FPS).
Specification: Refer to “Specification”
...
Categories
Hyundai Equus Manuals
2011-2026 Copyright www.heqmanual.com