Hyundai Equus: Hood
- Repair procedures
- Hood Assembly Components and Components Location
- Hood Assembly Repair procedures
- Hood Lift Repair procedures
- Hood Insulator Pad Repair procedures
- Hood Seal Weatherstrip Repair procedures
- Hood Weatherstrip Repair procedures
- Hood Latch Release Handle Components and Components Location
- Hood Latch Release Handle Repair procedures
- Hood Latch Components and Components Location
- Hood Latch Repair procedures
Repair procedures
Replacement
•
Be careful not to damage the fender and body.
•
When removing the clips, use a clip remover.
1.
Loosen the front wheel ...
Repair procedures
Adjustment
1.
After loosening the hinge (A) mounting bolt, adjust the hood (B) by moving it up or down, or right or left.
2.
Adjust the hood height by turning the hood overslam bumpers (C).
...
See also:
Presure Switch Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Exhaust Manifold Repair procedures
Removal and Installation
1.
Disconnect the negative terminal (A) from the battery.
Tightening torque :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
2.
Remove the engine room cover (A ...
Interior rearview mirrors
Before you start driving, adjust the rearview mirror to center on the view through
the rear window.
WARNING
Make sure your line of sight is not obstructed. Do not place objects in the
rear seat, ...
Categories
Hyundai Equus Manuals
© 2011-2025 Copyright www.heqmanual.com