>

Hyundai Equus: Accelerator Position Sensor (APS) Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Accelerator Position Sensor (APS) Repair procedures

Inspection
1.
Connect a scantool on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.

Specification: Refer to Specification Section.

    Accelerator Position Sensor (APS) Schematic Diagrams
    Circuit Diagram ...

    Rail Pressure Sensor (RPS) Description and Operation
    Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in ...

    See also:

    Rear Stabilizer Bar Repair procedures
    Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)     • Be careful not to damage ...

    4 seater
    Refer to your vehicle’s tire and loading information  label for specific information about your vehicle's capacity weight and seating positions. The combined weight of the d ...

    Filter replacement
    It must be replaced when necessary, and should not be washed. You can clean the filter when inspecting the air cleaner element. Clean the filter by using compressed air. Main air cleaner 1. ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com