>

Hyundai Equus: Heated Oxygen Sensor (HO2S) Specifications - Engine Control System - Engine Control/Fuel System - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Heated Oxygen Sensor (HO2S) Specifications

Specification
A/F Ratio (x)
Output Voltage(V)
RICH
0.6 ~ 1.0
LEAN
0 ~ 0.4

Item
Specification
Heater Resistance (x)
Approx. 9.0 [21°C(69.8°F)]

    Heated Oxygen Sensor (HO2S) Description and Operation
    Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies in ...

    Heated Oxygen Sensor (HO2S) Troubleshooting
    Signal Waveform Fig.1) The signal waveforms of front HO2S(the upper) and heater(the lower) at idle Fig.2) The signal waveforms of rear HO2S(the upper) and heater(the lower) at idle Fig.3) Typical ...

    See also:

    Rearview camera (If equipped)
      The rearview camera will activate when the back-up light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind ...

    Center Control Panel (CCP) Components and Components Location
    Components ...

    Fluid Repair procedures
    Service Adjustment Procedure Oil level Check     A check of ATF level is not normally required during scheduled services. If an oil leak is found, perform the oil level chec ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com