>
Hyundai Equus Manuals

Hyundai Equus: Camshaft Position Sensor (CMPS) Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Camshaft Position Sensor (CMPS) Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Camshaft Position Sensor (CMPS) Repair procedures

Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
   
•
DON’T remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine oil is hot and can cause burns.
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the camshaft position sensor connector (A).
3.
Remove the installation bolt (B), and then remove the sensor.
[Bank 1/Intake]

[Bank 1/Exhaust]

[Bank 2/Intake]

[Bank 2/Exhaust]

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
   
•
Apply the engine oil to the O-ring.
   
•
Insert the sensor in the installation hole and be careful not to damage.
   
•
Be careful not to damage the sensor housing and the connector.
•
Be careful not to damage the O-ring.
1.
Install in the reverse order of removal.
Camshaft position sensor installation bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
    Camshaft Position Sensor (CMPS) Schematic Diagrams
    Circuit Diagram ...

    Knock Sensor (KS) Description and Operation
    Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knockin ...

    See also:

    Troubleshooting
    Failure Diagnosis 1. In principle, ESP and TCS controls are prohibited in case of ABS failure. 2. When ESP or TCS fails, only the failed system control is prohibited. 3. However, when the ...

    Rear Glass Defogger Printed Heater Repair procedures
    Inspection     Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line. Apply finger pressure on the tin foil, moving the tin foil along th ...

    Troubleshooting
    Troubleshooting SymptomPossible causeRemedyOne lamp does not light(all exterior)Bulb or LED burned outReplace bulb or lamp assemblySocket, wiring or ground faultyRepair if necessaryHead lamps do ...

    Categories

    Hyundai Equus Manuals

    2011-2026 Copyright www.heqmanual.com