Hyundai Equus: Starter Relay Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Electrical System / Starting System / Starter Relay Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Electrical System / Starting System / Starter Relay Repair procedures
| Inspection |
| 1. |
Disconnect the battery negative terminal. |
| 2. |
Remove the fuse box cover. |
| 3. |
Remove the starter relay(A).
|
| 4. |
Using an ohmmeter, check that there is continuity between each terminal.
|
| 5. |
Apply 12V to terminal 85 and ground to terminal 86.
Check for continuity between terminals 30 and 87.
|
| 6. |
If there is no continuity, replace the starter relay. |
| 7. |
Install the starter relay. |
| 8. |
Install the fuse box cover. |
Starter Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the starter cable (A) from the B terminal on the solenoid, and the connector (B) from the S ter ...
See also:
Water pump Repair procedures
Removal and Installation
Water Pump
1.
Disconnect the negative terminal (A) from the battery.
Tightening torque :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
2.
Remove the air du ...
Distance to distance vehicle sensor
The sensor detects distance to the vehicle ahead.
If the sensor is covered with dirt or other foreign matter, the vehicle to vehicle
distance control may not operate correctly.
Always keep the ...
Rolling code programming
Rolling code devices which are "code-protected" and manufactured after 1996 may
be determined by the following:
Reference the device owner's manual for verification.
The handheld ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com