>
With the vehicle on level ground, check the fluid level in the power steering reservoir periodically. The fluid should be between MAX and MIN marks on the side of the gauge at the normal temperature.
Before adding power steering fluid, thoroughly clean the area around the reservoir cap to prevent power steering fluid contamination.
If the level is low, add fluid to the MAX level.
In the event the power steering system requires frequent addition of fluid, the vehicle should be inspected by an authorized EQUUS dealer.
CAUTION
Use only the specified power steering fluid. (Refer to "Recommended lubricants or capacities" in section 8.)
Repair procedures
Inspection
1.
After disconnecting the vapor hose from the PCV valve, remove the PCV valve.
2.
Reconnect the PCV valve to the vapor hose.
3.
Run the engine at idle, and put a finger on t ...
Purge Control Solenoid Valve (PCSV) Schematic Diagrams
Circuit Diagram
...
Specifications
Specifications
ItemsSpecificationsRated voltage5VLoadMax. 1mA (Relay load)Detection illuminationsTail lampON : 74 ± 16 (Lux), 2.36 ± 0.08 (V)OFF : 148 ± 32 (Lux), 4.52 ± 0.1 (V)Head lampON : 18.5 ...