>
1.Open the trunk, and remove the towing hook from the tool case.
2.Remove the hole cover by pressing the lower part of the cover on the front or rear bumper.
3.Install the towing hook by turning it clockwise into the hole until it is fully secured.
4.Remove the towing hook and install the cover after use.
Air Quality Sensor (AQS) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Connect the GDS.
3.
Check the output voltage of AQS between terminal 2 and 3.
1. DC 12V( Ignition)2. Sensor ground3. AQS signal
Specif ...
Rear Door Outside Handle Repair procedures
Replacement
1.
Remove the hole plug (B).
2.
After loosening the mounting bolt, then remove the rear door outside handle cover (A).
Tightening torque :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ...
CVVT (Continuously Variable Valve Timing) System Description and Operation
Description
Continuous Variable Valve Timing (CVVT) system advances or
retards the valve timing of the intake and exhaust valve in accordance
with the ECM control signal which is calculated by ...