>

Hyundai Equus: Photo Sensor Repair procedures - Air Conditioning System - Heating, Ventilation and Air Conditioning - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Photo Sensor Repair procedures

Inspection
1.
Turn the ignition switch ON.
2.
Connect the GDS.
3.
Emit intensive light toward the photo sensor using a lamp, and check the output voltage change.
4.
The voltage will rise with higher intensive light and reduce with lower intensive light.

1. Battery
2. LIN (Local Interconnect Network)
3. Ground

Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the inside rearview mirror cover (A).

3.
Disconnect the photo sensor (A), and then remove the sensor (B).

4.
Install in the reverse order of removal.
    Photo Sensor Description and Operation
    Description The photo sensor is located at the wind shield glass. The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar radiation received by its light receiving p ...

    Ambient Temperature Sensor Description and Operation
    Description The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower te ...

    See also:

    Rear Seat Back Cover Repair procedures
    Replacement [LH]     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and app ...

    Troubleshooting
    Troubleshooting Problem Symptoms Table Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor. ...

    Front Door Inside Handle Repair procedures
    Replacement 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Disconnect the front door inside handle lamp connector (A). 3. After loosening the mounting screws ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com