The ambient temperature sensor is located at the front of the
condenser and detects ambient air temperature. It is a negative type
thermistor; resistance will increase with lower temperature, and
decrease with higher temperature.
The sensor output will be used for discharge temperature
control, temperature regulation door control, blower motor level
control, mix mode control and in-car humidity control.
If the ambient temperature is below 1.0°C (33.8°F), the A/C compressor will stop.
The compressor will operate manually.
|
Inspection
1.
Turn the ignition switch ON.
2.
Connect the GDS.
3.
Emit intensive light toward the photo sensor using a lamp, and check the output voltage change.
4.
The voltage will ri ...
Inspection
1.
Turn the ignition switch OFF.
2.
Remove the front bumper.
(Refer to Body - "Front Bumper Cover")
3.
Disconnect ambient temperature sensor.
4.
Check the resistance of the ...
See also:
Components and Components Location
Components Location
1. Fuel tank2. Fuel pump3. Sub fuel sender4. Fuel filter5. Over Pressure Valve (OPV)6. Canister7. Fuel tank air filter8. Fuel Pressure Sensor (FPS)9. Fuel Level Sensor ( ...
Ignition Coil Schematic Diagrams
Circuit Diagram
...
Description and Operation
Description
System Overview
The larger the size of the door, the harder it is to close
it. Quite often we see people driving with a door not completely closed.
Power door latch addresses the is ...