Hyundai Equus: In-car Sensor Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / In-car Sensor Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / In-car Sensor Description and Operation
| Description |
An in-car air temperature sensor is located in the heater control.
The sensor contains a thermistor which measures the
temperature of the cabin. The signal determined by the resistance value
which changes in accordance with perceived inside temperature, is
delivered to the heater control unit and according to this signal the
control unit regulates the in-car temperature to the intended value.
Evaporator Temperature Sensor Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the evaporator temperature sensor connector.
3.
Measure the resistance between terminal “+” and “-” of the evaporator temp ...
In-car Sensor Repair procedures
Inspection
1.
Turn the ignition switch ON.
2.
Blow warm air into the in-car sensor air inlet. Measure the sensor resistance between 1 and 3 terminals.
1. Sensor Ground 2. Motor (-)3. Incar ...
See also:
To Reset the Power Trunk
If the battery has been discharged or disconnected, or if the related fuse has
been replaced or disconnected, reset the Power Trunk as follows:
1. Move the shift lever to the P(Park) position.
2. ...
Seat belt restraint system
WARNING
For maximum restraint system protection, the seat belts must always be
used whenever the car is moving.
Seat belts are most effective when seatbacks are in the upright position.
Chi ...
Output Speed Sensor Repair procedures
Inspection
1.
Check signal waveform of output speed sensor using the GDS.
Specification: Refer to "Signal Wave Form" section.
...
Categories
Hyundai Equus Manuals
2011-2026 Copyright www.heqmanual.com