Hyundai Equus: Repair procedures
| Diagnosis With GDS |
| 1. |
BSD system defects can be quickly diagnosed with the GDS. GDS
operates actuator quickly to monitor, input/output value and self
diagnosis. |
| 2. |
Connect the cable of GDS to the data link connector in driver side crash pad lower panel, turn the power on GDS. |
| 3. |
Select the vehicle model and then BSD system. |
| 4. |
Select "Current Data", if you want to check current data of BSD system.
|
| 5. |
If you want to check each module operation forcefully, select "Actuation test".
|
Description and Operation
Description
The BSD (Blind Spot Detection) system uses a radar sensor to alert the driver while driving.
It senses the rear side territory of the vehicle and provides information to the driver.
- ...
Blind Spot Detection Unit Schematic Diagrams
Circuit Diagram
...
See also:
Spliter Unit Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the floor console.
(Refer to Body - "Floor Console Assembly")
3.
Remove the spliter unit (A) after disconnecting the con ...
Blind spot detection system (BSD) (If equipped)
The BSD (Blind spot detection) system uses a radar sensor to alert the driver
while driving.
It senses the rear side territory of the vehicle and provides information to
the driver.
(1) BSD (B ...
Rear combination light bulb replacement
(1) Stop, tail light and side marker
(2) Rear turn signal light
(3) Back-up light
Rear back-up light
If the light is not operating, have the vehicle checked by an authorized EQUUS
dealer.
Tur ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com