>
Inspection |
1. |
Check "IPM" input/output specification of hazard lamp switch
using the GDS. If the specification is abnormal, replace the hazard
switch module. |
2. |
Select option "Input/output monitoring". |
Check battery and cables
Winter puts additional burdens on the battery system. Visually inspect the battery
and cables as described in section 7. The level of charge in your battery can be
checked by an authorized EQUUS d ...
8LR Brake Control Solenoid Valve Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Rear cross traffic alert
When your vehicle moves backwards from a parking position, the sensor detects
approaching vehicles to the left or right side direction and gives information to
the driver.
Operating condition ...