>
Hyundai Equus: Windshield Deicer Switch Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Using a screwdriver or plastic panel remover, remove the cluster fascia upper panel (A).
|
| 3. |
Using a screwdriver or plastic panel remover, remove the center fascia upper panel (A).
|
| 4. |
Disconnect the heater control unit connector (A), clock and SSB connector (B).
|
| 5. |
After loosening the screws, remove the heater control unit (A) from the center fascia upper panel.
|
| Installation |
| 1. |
Install the heater control unit to the center fascia upper panel. |
| 2. |
Install the center fascia upper panel. |
| 3. |
Install the cluster fascia upper panel. |
| Inspection |
| 1. |
Check IPM input/output specification of windshield deicer
switch using the GDS. If the specification is abnormal, replace the
windshield deicer switch module. |
| 2. |
Select option "Input/output monitoring".
|
| 3. |
To check the input value of windshield deicer switch in force mode, select option "Actuation test".
|
Windshield Deicer Repair proceduresSteering Wheel Remote Controller (SWRC) Repair procedures
Inspection
1.
Check for resistance between terminals in each switch position.
[LH Top (Audio)]
SwitchConnectorterminalResistance(±5%)Volume Down6-7240 xSeek Down510 xMode940 xVolume Up1.69 kxSe ...
Output Speed Sensor Description and Operation
Description
The output speed sensor is a vital unit that measures the
rate of rotation of the transmission's turbine shaft and output shaft,
and delivers the readings to the TCM. The sensor pr ...
Knock Sensor (KS) Schematic Diagrams
Circuit Diagram
...