>
Inspection |
1. |
Remove (-) negative battery terminal. |
2. |
Remove the front door trim.
(Refer to Body - "Front Door") |
3. |
Disconnect the motor connector from the motor. |
4. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction. If
the operation is abnormal, replace the motor. |
1. |
Remove (-) negative battery terminal. |
2. |
Remove the rear door trim.
(Refer to Body - "Rear Door") |
3. |
Disconnect the motor connector from the motor. |
4. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction. If
the operation is abnormal, replace the motor.
[Satety Window] |
Front Wiper Motor Repair procedures
Removal
1.
Remove the windshield wiper arm (A) and blade after removing a nut.
Tightening torque :
27 ~ 31 N.m (2.8 ~ 3.2 kgf.m, 20 ~ 23 lb-ft)
2.
If necessary of removing the wiper blad ...
Sedan Under Body
Under body
Projected dimensions
Tooling hole (O25)Front sub frame mounting pipe (O25)Tooling hole (O14)Front sub frame mounting pipe (O27)Tooling hole (O15)Tooling & paint drain hole (O6.6 ...
Height Sensor Repair procedures
Removal
[Front Height Sensor]
•
Avoid suffering excessive impact.
•
Do not entering the water into pin inside.
•
Take care not to be damaged height sensor witc ...