>
Hyundai Equus: Glove Box Housing Repair procedures
| Replacement |
|
|
| 1. |
Disconnect the stopper (B) from the glove box (A).
|
| 2. |
Disconnect the air damper (A) from the glove box (B).
|
| 3. |
Disconnect the pins (A) and then remove the glove box (B).
|
| 4. |
After loosening the mounting screws, then remove the glove box housing (A).
|
| 5. |
Disconnect the glove box lamp connector (A).
|
| 6. |
Install in the reverse order of removal.
|
Glove Box Housing Components and Components Location
Steering Column Shroud Panel Components and Components LocationTransmission Control Module (TCM) Repair procedures
Inspection
TCM Problem Inspection Procedure
1.
TEST TCM GROUND CIRCUIT: Measure resistance between TCM and
chassis ground using the backside of TCM harness connector as TCM side
check poin ...
Crankshaft Position Sensor (CKPS) Schematic Diagrams
Circuit Diagram
...
Troubleshooting
Troubleshooting
Ignition System
SymptomSuspect AreaRemedyEngine will not start or is hard to start (Cranks OK)Ignition lock switchInspect ignition lock switch, or replace as requiredIgnition c ...