>

Hyundai Equus: Rear Door Outside Handle Repair procedures - Rear Door - Body (Interior and Exterior) - Hyundai Equus VI 2009-2025 Service ManualHyundai Equus: Rear Door Outside Handle Repair procedures

Replacement
1.
Remove the hole plug (B).
2.
After loosening the mounting bolt, then remove the rear door outside handle cover (A).

Tightening torque :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

3.
Remove the rear door outside handle (A) by sliding it rearward.

4.
Disconnect the rear door outside handle connector (A).

5.
Install in the reverse order of removal.
   
•
Make sure the connector is connected properly.
•
Make sure the door locks/unlocks and opens/closes properly.
    Rear Door Outside Handle Components and Components Location
    Component Location 1. Rear door outside handle ...

    Body Side Molding
    ...

    See also:

    Transmission Control Module (TCM) Repair procedures
    Inspection TCM Problem Inspection Procedure 1. TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis ground using the backside of TCM harness connector as TCM side check poin ...

    Repair procedures
    Removal 1. Remove the steering column upper and lower shrouds after loosening screws. 2. Disconnect the multifunction switch connector (A). 3. Remove the wiper & washer switch (A) by p ...

    Trunk Lid Weatherstrip Repair procedures
    Replacement 1. Remove the trunk lid weatherstrip (A).     • Do not apply sealant to the body. 2. Install in the reverse order of removal.     â ...

    Categories

    Hyundai Equus Manuals

    © 2011-2025 Copyright www.heqmanual.com