>
Hyundai Equus Manuals

Hyundai Equus: Rear Door Module Repair procedures - Rear Door - Body (Interior and Exterior) - Hyundai Equus VI 2009-2025 Service ManualHyundai Equus: Rear Door Module Repair procedures

Second generation VI (2009–2025) / Hyundai Equus VI 2009-2025 Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Module Repair procedures

Replacement
1.
Remove the rear door window glass.
(Refer to Rear Door - "Rear Door Window Glass")
2.
Remove the rear door outside handle.
(Refer to Rear Door - "Rear Door Outside Handle")
3.
Loosen the rear door outside handle base mounting screw (A).

4.
Disconnect the rear door curtains motor connector (A).

5.
Using a screwdriver or remover, remove the extension cover (A).
6.
Loosen the mounting bolts, remove the rear door curtains (B).
Tightening torque :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

7.
Loosen the mounting bolts and nuts, remove the rear channel (A).
8.
Loosen the door latch (C) screws, remove the module assembly (B).
Tightening torque :
(B) 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
(C) 6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

9.
Disconnect the connectors (A) and rear door module wiring harness (B).

10.
Install in the reverse order of removal.
   
•
The area of whole parts should be applied with sufficient grease.
•
Make sure connectors are connected properly and each rod is connected securely.
•
Make sure the door locks/unlocks and opens/closes properly
    Rear Door Module Components and Components Location
    Component Location 1. Rear door module ...

    Rear Door Outside Handle Components and Components Location
    Component Location 1. Rear door outside handle ...

    See also:

    Damper Clutch Control Solenoid Valve Repair procedures
    Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the resi ...

    ETC (Electronic Throttle Control) System Repair procedures
    Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Throttle ...

    Wheel replacement
    When replacing the metal wheels for any reason, make sure the new wheels are equivalent to the original factory units in diameter, rim width and offset. ✽ NOTICE The front tire size is diff ...

    Categories

    Hyundai Equus Manuals

    © 2011-2025 Copyright www.heqmanual.com