>

Hyundai Equus: 6 Speed Clutch Control Solenoid Valve Repair procedures - Automatic Transmission Control System - Automatic Transmission System (SBC) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: 6 Speed Clutch Control Solenoid Valve Repair procedures

Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the resistance is within the specification.
    6 Speed Clutch Control Solenoid Valve Schematic Diagrams
    Circuit Diagram ...

    4&OD Clutch Control Solenoid Valve Description and Operation
    Description 4&OD Clutch control solenoid valve is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 4&OD Clutch. ...

    See also:

    Changing the engine oil and filter
    Have engine oil and filter changed by an authorized EQUUS dealer according to the Maintenance Schedule at the beginning of this section. CALIFORNIA PROPOSITION 65 WARNING Engine oil contains c ...

    Immobilizer system
    The immobilizer system protects your vehicle from theft. If an improperly coded key (or other device) is used, the engine’s fuel system is disabled. When the Engine Start/Stop Button is in the ON ...

    Rear Driveshaft (VL-VL TYPE) Repair procedures
    Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from rear hub.     Be carefu ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com